On Mittwoch, I said that I would complete the PICAXE-28 project board because I didn't get it all done last time.
To achieve this, I had to 1. Install the series of 330 Ohm resistors 2. Install the microcontroller 3. Test everything.
Did I achieve my goal? Yes, I did achieve my goal, I managed to install the resistors and install the microcontroller, I tested everything, and I also attached the wheels to the motors and soldered the female-female wires to the motors because I wanted to do extra because I finished it so quickly.
What went well? The soldering wasn't very difficult and everything seems to be working great.
What didn't go well? I BURNT MY FINGER SO MANY TIMES!!!!!!
It sucks when you burn the same finger over and over and over and over again. And on that note, Goodbye.
Oh yeah, this is a video of me soldering.
To achieve this, I had to 1. Install the series of 330 Ohm resistors 2. Install the microcontroller 3. Test everything.
Did I achieve my goal? Yes, I did achieve my goal, I managed to install the resistors and install the microcontroller, I tested everything, and I also attached the wheels to the motors and soldered the female-female wires to the motors because I wanted to do extra because I finished it so quickly.
What went well? The soldering wasn't very difficult and everything seems to be working great.
What didn't go well? I BURNT MY FINGER SO MANY TIMES!!!!!!
It sucks when you burn the same finger over and over and over and over again. And on that note, Goodbye.
Oh yeah, this is a video of me soldering.
RSS Feed
